FLOWBIRD STRADA PAL - Red Failure LED

STRADA PAL – MAINTENANCE MANUAL
144/149
9.2 Red failure LED
A red flashing LED means that the terminal is out of order. Contact the technical service
and provide the following information:
failure code,
failure message (the list below shows the most frequent),
if possible, a control ticket.
Display of a failure:
It is possible to view the "DIAGNOSTICS" code in hexadecimal corresponding to a
warning or a failure without opening the maintenance door.
Press simultaneously the "Cancellation" (red) and "Validation" (green) buttons on
the function keyboard or the extended keyboard.
Hold the "Cancellation" button until the "Release change button" message
appears.
Press the "Validation" button as many times as necessary to put the cursor on
the "Errors" function in the menu displayed.
Press the "Cancellation" button to select the function.
The terminal displays the list of the 20 most recent defaults and failures.
You can also open the maintenance door and use the keyboard to select the onsite
programming function 96.
Code
Failure message
Problem
Solution
4000
CHARGING BATTERY
MEASUREMENT
The voltage of the buffer battery
is too low when idle.
Replace the battery.
4001
IDLE BATTERY
MEASUREMENT
The voltage of the buffer battery
is too low when idle.
Replace the battery.
4002
SUPPLY FAILURE
The voltage of the battery is
insufficient.
Replace the battery.
4015
PAYMENT FAILURE
No means of payment available.
Replace at least one
means of payment.
4101
COIN BOX FAILURE
The coin box can no longer
accept coins.
Collect the coins.
4103
END OF COLLECTION NOT
REPORTED
Collection door not correctly
closed.
Check that the doors are
correctly closed.
4200
PRINTER FAILURE,
CHANNEL FORWARD
Printer broken or out of order.
Check operation of the
printer.
4201
PRINTER FAILURE,
CHANNEL CUT
Printer broken or out of order.
Check operation of the
printer.
4202
PRINTER FAILURE,
SENSOR FORWARD
Printer broken or out of order.
Check operation of the
printer.
4203
PRINTER FAILURE,
SENSOR CUT
Printer broken or out of order.
Check operation of the
printer.