Fluke 1550C - View Results Stored in Memory

Insulation Tester
Measurements
23
View Results Stored in Memory
Note
Parameters not appropriate for a test are shown as INVALID.
The Tester can store 99 sets of test data, including:
• Tags
• Ramp on or off
• Insulation Resistance
• Timer reading at termination of test (Timer)
• Test Voltage Selected (TV)
• Actual Test voltage (V)
• Capacitance I
• Polarization Index (PI)
• Dielectric absorption ratio (DAR)
• Test current (I)
• Reason for ending the test
• Limit – off or timer setting (1 to 99 minutes) (T. Limit)
To view stored test data, see Figure 11:
1. With the Tester turned on, push  to call the Function menu.
2. Push  or  to select 3. Show Results.
3. Push  to select the menu item.
Note
When a voltage is present at the terminals, that voltage is always
shown on the top-center of the display, regardless of whether that
voltage is sourced by the Tester or is from the circuit under test.