Fluke 190 Series II - Page 101

Tips
Changing the Auto Set Options
6
93
4
ENTER
Select 1 Hz and up, then jump to
Input Coupling:
When you press the
AUTO-MANUAL (auto set) key, the input
coupling can either be set to dc or left unchanged:
5
ENTER
Select Unchanged.
When you press the
AUTO-MANUAL (auto set) key glitch
capture can either be set to On or left unchanged:
6
ENTER
Select Unchanged.
Note
The auto set option for the signal frequency is
similar to the automatic trigger option for the
signal frequency. (See Chapter 4: “Automatic
Trigger Options”). However, the auto set option
determines the behavior of the auto set function
and shows only effect when you press the auto
set key.