Fluke 190 Series II - Resetting the Test Tool; Suppressing Key Labels and Menu’s

Fluke 190 series II
Users Manual
80
Using FlukeView
®
With the FlukeView
®
software you can upload waveform
data and screen bitmaps to your PC or notebook computer
for further processing.
USB drivers for the test tool and a FlukeView
®
Demo
version with restricted functionality are available on the
CD-ROM included in the shipment.
Connecting to a Computer
To connect the test tool to a PC or notebook computer and
use the FlukeView software for Windows
®
(SW90W), do
the following:
z Use a USB-A to mini-USB-B interface cable to
connect a computer to the mini USB PORT of the test
tool (See Figure 36).
z Install the test tool USB drivers, see Appendix A.
z Install the FlukeView
®
Demo version. For information
about installing and using the FlukeView
®
ScopeMeter software see the FlukeView
®
Users
Manual on the CD ROM.
Figure 36. Connecting a Computer
Notes
− The optional kit SCC290 contains an
activation code to convert the FlukeView
®
Demo version into a fully operational version.
− A complete FlukeView
®
version can be
ordered using ordering code SW90W. For
use with the Fluke Series II ScopeMeter test
tools FlukeView
®
ScopeMeter release V5.0
or higher is required.
− The test tool input channels are electrically
isolated from the USB port.
− Remote control and data transfer via mini-
USB is not possible while saving or recalling
data to or from the USB-stick..