Fluke 190 Series II - Page 120

Fluke 190 Series II
Users Manual
112
Trigger and Delay
Trigger Modes........................................Automatic, Edge,
Video, Pulse Width, N-Cycle,
External (190-xx2)
Trigger Delay ................................. up to +1200 divisions
Pre Trigger View ............................. one full screen length
Delay .................................................-12 div to +1200 div
Max. Delay.................................................. 60 s at 5 s/div
Automatic Connect-and-View Trigger
Source .............................................................. A, B, C, D
EXT (190-xx2)
Slope .......................................... Positive, Negative, Dual
Edge Trigger
Screen Update ............Free Run, On Trigger, Single Shot
Source......................................A, B, C, D, EXT (190-xx2)
Slope...........................................Positive, Negative, Dual
Trigger Level Control Range .......................... ±4 divisions
Trigger Sensitivity
DC to 5 MHz at >5 mV/div.......................... 0.5 divisions
DC to 5 MHz at 2 mV/div and 5 mV/div ...........1 division
500 MHz (FLUKE 190-502).............................1 division
600 MHz (FLUKE 190-502)........................... 2 divisions
200 MHz (FLUKE 190-2xx) .............................1 division
250 MHz (FLUKE 190-2xx) ........................... 2 divisions
100 MHz (FLUKE 190-1xx) .............................1 division
150 MHz (FLUKE 190-1xx) ........................... 2 divisions
60 MHz (FLUKE 190-062)...............................1 division
100 MHz (FLUKE 190-062)........................... 2 divisions
Isolated External Trigger (190-xx2)
Bandwidth ................................................................3 kHz
Modes .................................................... Automatic, Edge
Trigger Levels (DC to 3 kHz)...................... 120 mV, 1.2 V