Appendices
Instrument Security Procedures
C
C-3
3
Select DELETE with the up/down
arrow keys.
4
ENTER
Press ENTER.
5
F2
Press F2 – SELECT ALL.
6
ENTER
Press ENTER.
7
F4
Press F4 – YES to confirm the Clear
action.
If the test tool is not powered through its Power Adapter
removing the battery for 10 minutes will clear all data
stored in SRAM. For this proceed as follows: disconnect
the Test Tool from all voltage sources, open the battery
door present at the rear panel and lift the battery out of
the instrument.
To Next Page
Loading...
