Fluke 190 Series II - Displaying Recorded Data; Using Scope Record in Single Sweep Mode

Fluke 190 Series II
Users Manual
38
6
Observe the sensitivity of the
current probe. Highlight the
corresponding sensitivity in the
menu, e.g. 1 mV/A.
7
ENTER
Accept the current measurement.
Now, you will see a screen like in Figure 17
Figure 17. Ampere Measurement Readings
Selecting Auto/Manual Ranges
To activate manual ranging, do the following during any
Meter measurement:
1
MANUAL
AUTO
Activate manual ranging.
2
mV
V
RANGE
Increase (V) or decrease (mV)
the range.
Observe how the bargraph sensitivity changes.
Use manual ranging to set a fixed bargraph sensitivity and
decimal point.
3
MANUAL
AUTO
Choose auto ranging again.
When in auto ranging, the bargraph sensitivity and decimal
point are automatically adjusted while checking different
signals.