Fluke 5790B - Page 134

5790B
Operators Manual
6-44
EMULATE
Partially emulates a 5790A over the remote interface. This changes the model
number in the *IDN? response. “Partially” means the command execution speed
cannot be guaranteed when comparing a 5790A to a 5790B. If there are hard
coded delays in your remote commands, the delays may need to be altered if
issues are experienced. The 5790B does not support the 5790A commands:
CAL_PR and ETIME?
Parameter
F5790A selects 5790A emulation; anything else selects normal 5790B
behavior.
Example
EMULATE F5790A
Sets 5790A emulation.
EMULATE?
Returns the state of emulation as set by the EMULATE command.
Parameter
None
Response
(CRD) 5790A for 5790A emulation, 5790B for 5790B emulation.
ENETPORT
Sequential command. Sets the Ethernet port number.
Parameter
Port number
Example
ENETPORT 3490
Sets the Ethernet port number to 3490.
ENETPORT?
Sequential command. Returns the Ethernet port number.
Parameter
None
Response
(Integer) Ethernet port number
Example
ENETPORT?
Returns 3490 if the Ethernet port number is set to 3490