Fluke 5790B - Error; Flatness; Floor Error; Full Scale

5790B
Operators Manual
6-48
GWADDR
Sequential command. Sets the Ethernet gateway address for LAN
communication when NOT in DHCP mode.
Parameter
Gateway address (quoted string consisting of 4 decimal values bound
between 0-255 separated by periods).
Example
GWADDR "129.196.136.1"
Sets the Etherent gateway address to 129.196.136.1
GWADDR?
Sequential command. Returns the Ethernet gateway address for LAN
communication when NOT in DHCP mode. When in DHCP mode, the response
will be default.
Parameter
None
Response
String
Example
GWADDR?
Returns 129.196.136.1 if the gateway address is set to 129.196.136.1 and
DHCP is not enabled. Returns default if DHCP is enabled.
HIRES
Enables or disables higher resolution amplitude displays and remote responses
as defined in Table 4-5.
Parameter
ON or non-zero for on, or OFF or 0 for off
HIRES?
Returns the setting of the HIRES command for higher resolution amplitude
displays and remote responses as defined in Table 4-5.
Response
(Integer) 1 for on, or 0 for off