Fluke 5790B - Page 146

5790B
Operators Manual
6-56
REM_MODE
Sequential command. Sets the response type for a specified remote port.
Parameter
1. SERIAL, USB, ENET
2. COMP,TERM
Example
REM_MODE SERIAL, COMP
Sets the response type for serial communication to COMPUTER
REM_MODE ENET, TERM
Sets the response type for Ethernet communication to TERMINAL.
REM_MODE?
Sequential command. Returns the response type for a specified remote port.
Parameter
1. SERIAL, USB, ENET
Response
(CRD)
Example
REM_MODE? SERIAL
Returns TERM if the serial response type has been set to TERMINAL mode
REMOTE (For serial/USB/Ethernet port remote control only)
Puts the Product into the remote state. This command duplicates the IEEE-488
REN (Remote Enable) message.
Parameter
None
RPTSTR
Sets the user report string. The user report string can be read on the display in
local operation, and appears on calibration reports. Do not use control characters
(for example, CRLF, ^D, etc.) in the string.
Parameter
String of up to 132 characters
RPTSTR?
Returns the user report string. The user report string can be read on the display
in local operation, and appears on calibration reports.
Parameter
None
Response
(String) Up to 132 characters