Chapter 1: Get Acquainted
Overview of Memory Functions
25
TEST AGAIN: This button shows if the test failed. Tap this button
to do the test again for the same ID. If Auto Save is on, the tester
saves subsequent results with the same ID. If Auto Save is off,
you can save the result if necessary. When you look at a saved
result that failed, tap TEST AGAIN to do the test again for the
same ID and with the same test settings as the saved result.
TEST (yellow): This button shows if the test passed and Auto
Save is on. When Auto Save is on, the tester saves results with
the next available ID when the test is completed. When you tap
TEST, the tester does a test for the next available ID.
: Press to do the test shown on the home screen for
the Next ID.
Overview of Memory Functions
You can save approximately 30,000 fiber Autotest results.
The capacity available for test results depends on the space used
by the software and custom test limits in the tester.
To see the memory status
On the home screen, tap the TOOLS icon, then tap Memory
Status.
To make more memory available, you can export results to a USB
flash drive, then delete the results in the tester. See “Manage
Results on a Flash Drive” on page 107.
To Next Page
Loading...
