Fluke CertiFiber Pro - Settings for Fiber Tests

CertiFiber Pro Fiber Optical Loss Test Set
Users Manual
48
Settings for Fiber Tests
Table 2 gives descriptions of the settings for fiber tests. To set up
a project, which includes the settings in Table 2, cable IDs, and
operator names, see Chapter 8.
To set up a fiber test
1 On the home screen, tap the test setup panel.
2 On the CHANGE TEST screen, select a fiber test to change,
then tap EDIT.
Or to set up a new fiber test, tap NEW TEST. If no module is
installed, the MODULE screen shows. Tap the correct CertiFiber
Pro module.
3 On the TEST SETUP screen, tap the panels to change settings
for the test. See Table 2.
4 On the TEST SETUP screen, tap SAVE when your test setup is
completed.
5 On the CHANGE TEST screen, make sure the button next to
the test is selected, then tap USE SELECTED.