Fluke CertiFiber Pro - How to Clean Fiber Endfaces; How to Use a Fluke Networks IBC OneClick Cleaner; How to Use Wipes, Swabs, and Solvent; To Clean Bulkhead Connectors

ii
CertiFiber Pro Fiber Optical Loss Test Set
Users Manual
How to Remove and Install the Connector Adapters .. 27
How to Install a Strap .................................................... 29
How to Remove or Install a Module ............................. 29
About LinkWare and LinkWare Stats Software ........... 31
Chapter 2 How to Clean Fiber Endfaces
How to Use a Fluke Networks IBC OneClick Cleaner ... 36
How to Use Wipes, Swabs, and Solvent ........................ 38
To Clean Bulkhead Connectors ...............................
38
T
o Clean the Optical Connectors on the Modules . 39
To Clean Fiber Adapters .......................................... 39
To Clean Connector Ends ........................................ 39
Chapter 3 How to Certify Fiber Cabling
Requirements for Reliable Fiber Test Results ............... 41
About the Reference for Fiber Tests ....................... 42
When to Set the Reference .............................. 42
Good Reference Values ..................................... 43
How to See the Reference Values .................... 44
About Test Reference Cords and Mandrels ............ 44
About the EF-TRC (Encircled-Flux 
Test Reference Cords) ....................................... 44
About APC Connectors ......................................
46
About
Standard Mandrels ................................ 47
Settings for Fiber Tests ...................................................
48
About
1 Jumper Reference Connections ...................... 55
Autote
st in Smart Remote Mode .................................. 55
Step 1: Set the Reference in Smart 
Remote Mode .......................................................... 57