Fluke CertiFiber Pro - How to Certify Fiber Cabling; Requirements for Reliable Fiber Test Results; About the Reference for Fiber Tests; When to Set the Reference

Contents
iii
Step 2: Measure the Loss of the Test 
Reference Cords You Will Add ................................59
Step 3: Do an Autotest in Smart Remote Mode .....60
Autotest Results for Smart Remote Mode ..............61
Fiber IDs for Saved Results in Smart 
Remote Mode ...........................................................61
Autotest in Loopback Mode ..........................................
6
4
Step 1: Set the Reference in Loopback Mode .........66
Step 2: Measure the Loss of the Test 
Reference Cord You Will Add ..................................68
Step 3: Do an Autotest in Loopback Mode .............69
Autotest Results for Loopback Mode ......................70
Autotest in Far End Source Mode ..................................72
Auto Wavelength Modes .........................................72
Step 1: Set the Reference in Far End 
Source Mode .............................................................74
Step 2: Measure the Loss of the Test 
Reference Cord You Will Add ..................................77
Step 3: Do an Autotest in Far End Source Mode ....77
Autotest Results for Far End S
o
urce Mode .............78
Bi-Directional Tests .........................................................80
Chapter 4 The FiberInspector Test
How to Do the FiberInspector Test ................................83
Chapter 5 The Visual Fault Locator
Visual Fault Locator Applications ..................................89
How to Use the VFL ........................................................90
Chapter 6 The Power Meter and Light Source
How to Monitor Power and Loss ...................................93