Visual IR Thermometer
Power On and Off
5
Power On and Off
To turn on the Product, push and hold for 2 seconds. A start-up screen
shows on the display and an indicator bar shows the status, see Figure 1. The
indication bar increases on power up and decreases on power down. After the
start-up screen, the Product is ready to use. To turn off the Product, push and
hold for 2 seconds.
The Auto Off feature turns off the Product after 10 minutes of inactivity.
VT02 VT04
hak03.eps
Figure 1. Start-Up Screen and Status Indicator
For the first time use, or when the batteries are removed for more than a few
hours, the Date and Time menu opens. See page 18 for more information about
how to set the date and time.
Note
All visual IR thermometers need sufficient warm-up time for the most
accurate temperature measurements. This time can often vary by
model and by environmental conditions. Although most visual IR
thermometers are fully warmed up in 3 to 5 minutes, it is always best
to wait a minimum of 10 minutes if the most accurate temperature
measurement is very important to your application. When you move a
visual IR thermometer between environments with large differences in
ambient temperature, more adjustment time can be required.
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.com
To Next Page
Loading...
