7.7 Student Mode
Student mode is used when another system is connected as a master (Trainer), when this mode is active
all settings will be bypassed and the system will only function through the master.
Setup:
1. To enable the function press "OK" then select Yes, The system will return to the previous menu.
2. To exit student mode repeat this process.
7.8 Sticks Mode
There are 4 available stick modes, each stick mode changes the stick functions.
For example when using stick mode 2 the left stick controls throttle on the vertical axis and rudder in the
horizontal axis, however in stick mode 3, the vertical axis controls elevator and the horizontal axis controls
aileron. These modes are largely down to personal preference.
Setup:
1. Use the "UP" and "DOWN" keys to select a stick mode,.
2. Press and hold the "CANCEL" key to save and exit.
3. To return to default settings press and hold the "OK" key for 3 seconds,press and hold the "CANCLE"
key to save.
7.9 LCD Brightness
Setup:
1. Use the "UP" and "DOWN" keys.
2. Press and hold "CANCEL" to save and exit.
3. To return to default settings press and hold the "OK" key for 3 seconds,press and hold the "CANCLE"
key to save.
7.10 Firmware Ver.
This function displays the current firmware version.
7.11 Firmware Update
This function updates the firmware using a USB to PS/2 connection lead.
Setup:
1. First download the update from our website.
2. Connect the system to the computer via the supplied cable and press "OK" while in this function.
3. Wait for windows to recognise the system.
4. Then open the update on the computer and press update.
5. Once the update is finished cycle the system power.
7.12 Factory Reset
This function resets the entire system back to its factory settings.
To reset press "OK",then use the "UP" and "DOWN" keys to select Yes and press 'OK" again.
To Next Page
Loading...
Need help?
General
