9. System Customization
The FS-i6X's switches and knobs can be moved
to other channels. Or if using receivers with more
channels, the system can be expanded with extra
switches or knobs.
By default, from left to right, the switches and knobs
are channels 5, 6, 7, 8, 9 and 10.
FS-A6/FS-iA6B 6CH
FS-iA10B 6-10CH
5
6 7 8 9
10
9.1 Switching Channel Assignments
To change a switch or knobs channel, the system
must be taken apart. The first step is taking the back
cover off.
1. Remove any batteries from the system and
replace the battery cover.
2. Remove the screws marked in green.
Note
• Make sure the screw driver
you are using is not too big
or too small. Failure to do so
could damage the head of
the screw.
3. Carefully pry the front and back apart, this may
take some force.
Note
• Don't pull the pieces too
far apart, doing so could
damage cables attacking the
front and back together.
4. Carefully disconnect the cables connecting the front to the back.
Note • Make sure you keep the screws in a safe place.
To Next Page
Loading...
Need help?
General
