1. Use the "UP" and "DOWN" to choose a channel and press "OK" to enter its failsafe settings.
2. Use the "UP" and "DOWN" to turn the failsafe on or off.
3. Move the channels control surface to the desired position and hold the "CANCEL" key to confirm and
exit.
4. To return to default settings press and hold the "OK" key for 3 seconds,use the "UP" and "DOWN"
keys to select Yes. press and hold the "CANCLE" key to save.
You can set the failsafe position for all channels with the[All channels] button at once. To do so,
1. Move all your channels to the desired position.
2. Select [All channels].
• Oncethefailsafehasbeenset,apercentagewillbedisplayed.
8.5 Sensors List
This function displays all connected sensors and thier outputs.
8.6 Choose Sensors
This function changes which sensors will be displayed on the home screen. The home screen can display
up to 3 sensors.
Setup:
1. To add a sensor to the home screen, use the "OK" key to change sensor slot, then use the "UP" and
"DWON" keys to select a sensor.
2. To return to default settings press and hold the "OK" key for 3 seconds, Press and hold the "CANCEL"
key to save and exit.
8.7 Speed and Distance
This function is for setting up speed and distance sensors.
Speed Sensor
If a sensors is connected, us the "UP" and "DOWN" arrow keys to select the desired senor then press and
hold the "CANCEL" key to save.
Rotation Length
Measure the distance from the center of the prop to the distance sensor. Then use the "UP" and "DOWN"
arrow keys to enter the length. Press and hold the "CANCEL" key to save.
Reset Odometer 1 + 2
These settings return the odometer to 0. To reset select one, odometer 1 or 2, then press "OK". The
system will display a prompt, select yes.
Reset odometer 1
Resets odometer 1 to 0. Odometer 1 records the distance traveled during a session. Note that restarting
the system will also reset odometer 1.
Reset odometer 2
Resets odometer 2 to 0. Odometer 2 records the total distance traveled since last reset. This means that
the distance over several sessions will be added together.
To Next Page
Loading...
Need help?
General
