7.13 Aux Switches
This function both activates and deactivates switches/knobs as well as changing the amount of active
channels the system will use. This is usually done when a new switch or knob has been.
Setup:
1. Use the "OK" key to cycle through the selection of switches and knobs.
2. Use the "UP" and "DOWN" keys to turn the selected switch/knob on or off.
3. Keep pressing the "OK" key until "Ch" is selected.
4. Use the "UP" and "DOWN" keys to change the amount of active channels to match your current
configuration.
5. To return to default settings press and hold the "OK" key for 3 seconds,press and hold the "CANCLE"
key to save.
To Next Page
Loading...
Need help?
General
