136
4. Safety instructions for all electrical systems
Read all the safety instructions and regula-
tions.
Non-compliance with the safety instructions and
regulations may lead to electric shock, re and/
or severe injuries.
Keep all safety instructions and regulations
for future use.
The term “battery” in these operating instructions
refers to all standard batteries.
Your FLYER is supplied with the corresponding
operating manual for the integrated motor from
the component manufacturer. You are strongly
advised to carefully read the attached instructions
manual to the electric drive system before you
use your bike for the rst time. You should also
pay close attention to the safety guidelines.
Information concerning the FLYER e-bike’s oper
-
ation, maintenance, care and technical data can
be found in this manual and online on the respec
-
tive websites to the manufacturers’ components.
Remove the battery from the e-bike be-
fore you begin working on the it (i.e. in-
stallation, maintenance, working on the
chain). The same applies when storing
the bike or transporting it on a car, train
or airplane.
There is a risk of injury if the electrical
system is unintentionally activated.
The electric drive system built into your
FLYER e-bike is extremely powerful.
Correct and safe operation requires you
to have your FLYER regularly main
-
tained by a specialist retailer. Immedi-
ately remove the battery when you no-
tice damage to the electrical system,
particularly when live parts are exposed
after an accident. Always contact your
FLYER specialist retailer when you re
-
quire repairs, want to ask a question,
have a problem or discover a defect. A
lack of technical knowledge can lead to
severe accidents, injuries or damage.
The FLYER was designed for driving
with the motor. Never drive without a
battery or with the system switched off,
as no light will be available without the
battery or system.
Your FLYER has an automatic protection
against overheating. In the case of over
-
heating, this protection will switch off the
motor function until the motor has
reached a non-critical temperature. The
remaining functions are continued, e.g.
you can still drive with the lights on.
When the bike is not in use, the system
will automatically turn off together with
the light function after 10 minutes.
Therefore, always be sure to turn on the
display before each ride.
To Next Page
Loading...
Need help?
General
