EasyManua.ls Logo

FlyTech POS485 - 3-5. RAM Replacement

FlyTech POS485
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
Removing a RAM module
1. To remove the module pull the
ejector clips out of the side of the
module.
2. Slide the memory out of the slot.
3-5.
RAM Replacement
1. Follow the steps in Chapter 3-4 to
open the system.
2. The RAM is located on the right side
of the system (see picture).
Installing a RAM module
3. Slide the memory module into the
memory slot and press down until it
locks in place.

Related product manuals