Forma Scientific, Inc.
____________________________________________________________________________
4-11
Securely attach the gas lines from the supply tank to the desired barbed inlet fitting(s)
located on the back of the unit. The fittings are labeled. Refer to Figure 4-6. Check the
connections for leaks.
Rear view of the control panel, stacked model without Gas Guard
Figure 4-6
4.13 FILLING THE HUMIDITY RESERVOIR OR PAN
Do not use plastic pans for humidification as they will have an unpredictable effect on
humidity and O
2
/CO
2
levels in the incubator. Use only the floor of the unit or the
optional stainless steel humidity pan.
Do not use de-mineralized or de-ionized water in the humidity reservoir or pan unless
it has been boiled immediately prior to use as it may be contaminated with bacteria.
Listed below are two recommended methods of providing elevated humidity in the
chamber.
Note: Frequent door openings will cause humidity loss from chamber and may result in
desiccation of the product. Recovery time will also be affected.
To Next Page
Loading...
