Fortinet FortiMail 3.0 MR4 - System Ha Mode

set system ha mode
FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
06-30004-0420-20080814 321
system ha mode
Use this command to set the HA configured operating mode of the FortiMail unit. The FortiMail unit
switches to operating in the HA configured operating mode immediately after you enter this command.
Syntax
set system ha mode <mode>
Example
Enter the following command to set the HA configured operating mode of a FortiMail unit to cmaster.
set system ha mode cmaster
History
Related topics
Keywords/Variables Description Default
mode <mode> Set the HA configured operating mode of the FortiMail unit. The
configured operating mode can be:
• off if the FortiMail unit is not operating in HA mode.
• master if the FortiMail unit is the primary unit in an
active-passive HA group.
• slave if the FortiMail unit is the backup unit in an
active-passive HA group.
• cmaster if the FortiMail unit is the primary unit in a config
only HA group.
• cslave if the FortiMail unit is the backup unit in a config
only HA group.
off
FortiMail v3.0 New.
• set system ha config
• set system ha {cpeer | interface | peer |
secondary-interface | secondary-peer}
• set system ha data
• set system ha datadir
• set system ha lservice
• set system ha monitor
• set system ha on-failure
• set system ha passwd
• set system ha remote-as-heartbeat
• set system ha {restart | restore | resync}
• set system ha rservice
• set system ha takeover