Fortinet FortiMail 3.0 MR4 - System Route Number

set system route number
FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
06-30004-0420-20080814 339
system route number
Use this command to set and configure system routing.
Syntax
set system route number <route_int> dev1 {auto | port1} dst <route_ip4>
<mask_ip4> gw1 <gway_ip4>
History
Related topics
• set system interface config
• set system interface mode static
Keywords and Variables Description
number <route_int> Enter the number of the route in the routing table. The default route is 0.
dev1 {auto | port1} Sets the FortiMail traffic-routing interface to auto or port1.
In auto, the FortiMail unit routes traffic to the interface that is on the same subnet
as gw1.
dst <route_ip4>
<mask_ip4>
Sets the FortiMail unit route destination IP address and IP address mask.
<route_ip4> is the destination IP address. <mask_ip4> is the IP address mask.
gw1 <gway_ip4> Sets the FortiMail unit route primary gateway IP address.
<gateway_ipv4> is the primary gateway IP address.
FortiMail v3.0 New.