Fortinet FortiMail 3.0 MR4 - System Time Ntp

FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
344 06-30004-0420-20080814
system time ntp set
system time ntp
Use this command to set and configure system time settings using network time protocol (NTP).
Syntax
set system time ntp dst {disable | enable} ntpserver <ipv4 | hostname>
ntpsync {disable | enable} syncinterval <sync_interval> zone <zone_num>
History
Related topics
• set system time manual
Keywords and Variables Description
dst {disable | enable} Enable or disable daylight saving time (DST).
ntpserver <ipv4 | hostname> Enters NTP server IP or hostname.
• <ipv4> is the NTP server IP address.
• <hostname> is the NTP server hostname
ntpsync {disable | enable} Enable to synchronize the FortiMail unit with the NTP server.
syncinterval <sync_interval> Enter the system synchronization time interval from one to 1440
minutes.
zone <zone_num> Enter the required time zone by number. Use ‘?’ to see a list of zone
names and their numbers.
FortiMail v3.0 New.