Fortinet FortiMail 3.0 MR4 - Ping-Option

FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
38 06-30004-0420-20080814
ping-option execute
ping-option
Use this command to configure the ping function behavior settings.
Syntax
execute ping-option <option>
History
Related topics
• execute ping
Option Description Default
data-size <bytes> Enter datagram size in bytes. 56
df-bit {yes | no} Enter yes to set the DF bit in the IP header to prevent the ICMP
packet from being fragmented. Setting df-bit to no allows the
ICMP packet to be fragmented.
no
pattern <hex_pattern> Enter a pattern to fill the optional data buffer at the end of the
ICMP packet, for example 00ffaabb. The size of the buffer is
specified using the data_size parameter. This allows you to
send out packets of different sizes for testing the effect of
packet size on the connection.
None
repeat-count <integer> Enter the number of times to repeat the ping. The value must be
greater than 0.
5
source {auto | <ipv4>} Select the interface from which the ping is sent. Enter either
auto or the interface IP address.
auto
timeout <seconds> Enter the ping response timeout in seconds. 2
tos <tos_value> Enter the IP type-of-service option value, one of:
• default 0
• lowcost minimize cost
• lowdelay minimize delay
• reliability maximize reliability
• throughput maximize throughput
default
ttl <TTL_integer> Enter the time-to-live (TTL) value. 64
validate-reply {yes | no} Enter yes to validate ping replies. no
view-settings View the current ping option settings. N/A
FortiMail v3.0 New.