21
Recording Your Custom Message
When the alarm is triggered, and a phone line or SIM card
is connected, the system will call out and play your custom
message to the person who answers the call. You can re-
cord a custom message up to 15 seconds in length.
For example, you may wish to record something like the
following: “e burglar alarm has been triggered at (street
address). Please send help.”
To record or re-record your custom message:
1. Press and release the Power button. e light on the
panel will begin to ash blue.
2. Press and release the Set button. e panel will say,
“Voice message recording.”
3. Speak your message clearly. When nished, either
press and release the Power button to exit, or allow the
panel to time out on its own.
To delete your custom message:
1. Press and release the Power button. e light on the
panel will begin to ash blue.
2. Press and release the WiFi button. e panel will make
a sharp “crash” sound to indicate the recording has been
deleted.
3. Either press and release the Power button to exit, or
allow the panel to time out on its own.
To Next Page
Loading...
Need help?
General
