44
en, set the siren into programming mode. e steps for
doing that depend on which type of siren you’re adding.
See the following pages for instructions on setting your si-
ren into programming mode.
Once the siren is in programming mode, press the central
button on the main panel to send a signal to the siren. e
siren should chirp in response.
To nish programming the siren, unplug it and/or turn it
o for at least 10 seconds.
Your siren is now programmed. You can plug in the siren
anywhere within range of the main panel, and test it when
you’re ready by triggering the alarm to conrm the siren
will sound.
Setting Wireless Sirens into Programming Mode
Each of the wireless sirens compatible with the S1 GSM
WiFi system can be set into “programming mode” as part
of the process to add it to your system. Here are the details
for each type of wireless siren that we oer now.
(see next pages)
To Next Page
Loading...
Need help?
General
