105
Flashing
Flashing
• In the saving operation using more than one disk, if
you use a disk in which save data is already recorded:
When carrying out step 6 above, an existing
program number is shown. In this condition, by
using the [JOG] dial, you can select "Eject", as well as
existing programs.
To eject the disk, select "Eject" and press the [ENTER/
YES] key.
If you save data to the disk, select any existing
program and press the [ENTER/YES] key.
The display shows "Delete All" and "Sure?" (flashing)
as below.
Press the [ENTER/YES] key while the above screen is
shown.
All backup data recorded in the disk are erased and
then the save operation starts.
Loading from a single SCSI disk
You can load data using the "Load PGM" menu in the
SETUP mode. The following procedure shows how to
load song data saved to a single SCSI disk. See the
next section for loading data saved to more than one
SCSI disk.
<Details about "Load PGM" menu>
•Input signal options:
OPT (adat or S/PDIF), SCSI or IDE (CD-1A)
•Program options: P01 to P99 (an individual Program)
•Track options:
* When using S/PDIF or adat:
Tracks 1-8, Tracks 1-16, Tracks 1-24, Tracks 9-16,
Tracks 9-24 or Tracks 17-24.
* When using a SCSI disk:
All tracks (1-24) is selected automatically. (You can
select tracks individually when loading a WAV file).
<Note>
: You cannot load data from a CD-RW/CD-R disc by
the WAV file format.
1. Press the [SETUP] key to enter the Setup mode.
The display shows the screen for selecting the Setup menu.
2. Use the [JOG] dial to select "Load PGM" and press the
[ENTER/YES] key.
The display shows the screen for selecting the device from
which the data is loaded. "IDE" flashes.
3. Press the [REWIND] key to select "SCSI" and press the
[ENTER/YES] key.
The display shows the screen for selecting the program
to be loaded.
The backup number currently selected flashes, while the
data size of the program is shown. While a backup number
is flashing, you can select the desired program to be
loaded. If a disk has more than one program saved, you
can select the desired program by using the [JOG] dial.
• You can also select "
Eject"
as well as programs to be
loaded in the condition above.
To eject the disk, press the
[ENTER/YES]
key after
selecting "
Eject
".
4. Use the [JOG] dial to select the program to be loaded and
press the [ENTER/YES] key.
The display shows the screen for selecting the destination
program to which data is loaded.
In the default setting, "New PGM" is selected so that the
data is loaded to a newly created program.
To Next Page
Loading...
