144
*a blank panel
*two screws for mounting the drive
*a CD-RW drive unit
Installing the CD-1A
<Usable discs>
With the CD-1A, you can use discs of following
types.
<CD-R discs>
Can be used for saving or loading song
data, as well as making an audio CD.
Note that you can record data to a CD-R
disc only once. You cannot record data
to a disc which has been recorded be-
fore.
<CD-RW discs>
Can be used for saving or loading song
data, as well as making an audio CD.
You can record or erase data to a CD-R
disc as many times as wish.
<Audio CD discs>
As these are read-only discs, you only
can use them for loading track data to
the VF160.
See the VF160 operation manual for details about how
to save/load song data or how to make an audio CD.
<Notes on handling of discs>
• When handling a disc, be careful not to dirty or scratch
the surface of the disc.
We recommend that you hold the disc with your fin-
ger on the disc edge and center hole.
• Do not stick any paper, etc. on the label side.
Also do not scratch the label side, which may cause
problems during playback or recording. Use only a
felt pen or equivalent for writing any memo on the
label side. Using a ball-point pen, pencil, etc. that has
a hard tip may damage a disc.
• Never use a warped or chipped disc, which may dam-
age the CD-RW drive.
• If there is a dust, dirt or fingerprints on the disc, which
may cause error in playback or recording, wipe the disc
with a soft, dry cloth or alcohol from the center out.
Never wipe from the outside to center.
• Do not use a cleaner for analog discs or antistatic spray,
as well as volatile solvents such as benzine, which may
damage the disc surface.
• Do not expose any disc to direct sunlight, or leave it in
hot, moist or cold places.
• Read the attached manual packed with the disc before
using it.
<Notes on care of disc>
To Next Page
Loading...
