F3D3 Series Service Manual Factory Level 3 Parameter Access / 1.11.2
Questions? Call Franke Technical Support Group For Your Area. Copyright 2012 Franke, Inc. All rights reserved.
Factory Level 3 - Parameter Guide – Page 1
[For Models with firmware version F3D3 Main H47C1 ONLY
1)
]
5=French/English (Canada)
-30 30 Deg F 8 Temperature offset from sensor
Temperature that triggers a high
High Alarm (Start
Up) Delay
Time to wait after high alarm
signal, until message appears
Temperature must remain (dwell)
for this time
Used in temperature control
Used to correct onboard time
Minimum time the compressor
must be off before restarting.
Time for a size downshift from
large to medium. 20 = Off
Time for an initial size downshift
from medium to small. 20 = Off
Time for subsequent size
downshift from medium to small.
Motor stops if threshold
exceeded. Approx 250
counts/amp of motor current.
Motor stops if threshold
exceeded. Approx 250
counts/amp of motor current.
Motor stops if threshold
exceeded. Approx 250
NOTES: 1) Software version is printed on label on Main Control Board Chip.