Freestyle 80 - Installer and Inquiry Modes

Part number 550-142-850/0716
91
FreeStyle
®
WALL MOUNT GAS-FIRED WATER BOILER — Boiler Manual
32 Troubleshooting(continued)
Figure 115)NSTALLERMODEFORFreeStyle
®
BOILERS
Installer mode
"YPRESSINGTHE2%3%4PUSHBUTTONFORSECONDSITISPOSSIBLETOENTEREDTHE)NSTALLERMODE$URINGTHISTIMETHE/4#MODE
MUSTNOTBEENTERED4HEDISPLAYSTARTSSHOWINGhT3vmASHING"YMEANSOFTHE#(AND#(PUSHBUTTONSITISPOSSIBLETOSELECT
“tS” or “In” or “Hi” or “rE”. “tS” means “Transparent parameter”; “In” means “Inquiry”; “Hi” means “History”; “rE” means “Reset”.
"YMEANSOFTHE2ESETBUTTONACTIVATIONFORSECONDONhT3vITISPOSSIBLETOENTERTHEh4RANSPARENTPARAMETERvMODEONh)NvIT
ISPOSSIBLETOENTERTHEh)NQUIRYvMODEONh(IvISPOSSIBLETOENTERTHEh(ISTORYvMODEBYMEANSOFTHE%#/BUTTONACTIVATION
FORSECONDSONhR%vISPOSSIBLETORESETALLTHE(ISTORYINFORMATION
"YPRESSINGTHE$(7AND$(7PUSHBUTTONSTOGETHERFORSECONDSITISPOSSIBLETOLEAVETHE)NSTALLERMODE)FNOACTIONHAS
BEENTAKENTHECONTROLAUTOMATICALLYLEAVESTHISMODEAFTERMINUTES
“tS” as Transparent Parameters mode (TSP)
Selecting “tS” the display starts with showing “0vBLINKING"YMEANSOFTHE#(AND#(PUSHBUTTONSITISPOSSIBLETOSELECT
the parameters; between “0” and “0v3ELECTINGONEOFTHESEPARAMETERSBYMEANSOFTHE$(7AND$(7PUSHBUTTONSIS
possible to adjust his value (not flashing). The value is automatically saved.
Parameter Description Default Note
P01
Ignition level (%) 60 or 80
(60% - FS-120/80% - FS-80)
60% - FS-155)
P02
CH slope control (°F/min) 11
P03
Minimum Virtual set point (°F) 95
P04
CH OFF time (Min) 2
P05
CH pump over-run time (Min) 15
P06
CH pump selection (0-7) 0
P07
CH modulating pump PWM absolute min (%) 30
P08
CH modulating pump PWM start (%) 75
P09
CH modulating pump PWM absolute max (%) 100
P10




122
68
91
68
DHW conf. dependent
P11




18
9
18
9
DHW conf. dependent
P12
CH set point limit HIGH (°F) 190
P13
CH maximum output (%) 100 Also in Test Mode
tS blinking
Transparent parameter mode
In blinking
Inquiry mode
Hi blinking
History mode
rE blinking
Reset all the History information
Figure 116hT3v4RANSPARENT0ARAMETERMODEFORFreeStyle
®
BOILERS