FREEWAY S180 Mobile - Attachment Bracket Removal and Replacement

39 pages

To Next Page

To Previous Page

995367 – Revision A Page 20 of 39

9.4 – Attachment Bracket

In this section it will explain the correct procedure on removing and reinstalling the

Attachment Bracket for servicing procedures or replacement.

Removal

Step 1 – Remove the Battery (refer to section 9.1)

Step 2 – Remove the Cables/Leads from the Control Box (refer to section 9.2)

Step 3 – Remove the Control Box (refer to section 9.3)

Step 4 – Using a 3mm Allen Key and an 8mm Spanner, remove the three circled screws and

nuts to release the Attachment Bracket.

Refitting / Replacement

Step 5 - Refitting is a reversal of the removal process.