995367 – Revision A Page 35 of 39
9.12 – Base
Within this section it will explain the correct procedure on removing and reinstalling the
Base for servicing procedures or replacement.
Removal
Step 1 – Unplug the Leg Actuator Cable from the Control Box.
Step 2 – Remove the Mast/Base connector Bolt by twisting the Star-Knob anti-clockwise
until the bolt detaches.
Step 3 – Remove the Star Knob from the Base.
Step 4 – Raise the Mast of from the Base by lifting it vertically upward.
To Next Page
Loading...