FREEWAY S180 Mobile - Boom Removal and Replacement

To Next Page

To Previous Page

995367 – Revision A Page 36 of 39

Step 5 – Remove the Leg Actuator Cover from the Base. (Refer to section 9.8)

Step 6 - Remove the Leg Actuator (Refer to section 9.6)

Step 7 – Remove the LH Leg and the RH Leg from the Base. (Refer to section 9.11) – The

Castors are not required to be removed.

Refitting / Replacement

Step 8 - Refitting is a reversal of the removal process noting the following point:

A) Ensure the Star Knob is fully tightened to disallow any play between the Mast and Base

of the Hoist.

9.13 – Boom

Within this section it will explain the correct procedure on removing and reinstalling the Boom for

servicing procedures or replacement.

Removal

Step 1 – Remove the Lift Actuator Cable. (See section 9.2.2)

Step 2 – Remove the Lift Actuator. (See section 9.5)

Step 3 – Remove the Carry Bar. (See section 9.7)

Step 4 - Remove the plastic end cap from the Boom using a tool such as a flat head

screwdriver.