FREEWAY S180 Mobile - Leg Actuator Removal and Replacement

To Next Page

To Previous Page

995367 – Revision A Page 23 of 39

9.6 – Leg Actuator

Within this section it will explain the correct procedure on removing and reinstalling the Leg

Actuator for servicing procedures or replacement.

Removal

Step 1 – Remove the Leg Actuator Cable. (Refer to section 9.2.3)

Step 2 – Follow steps 1-4 from section 9.12 (Base Removal) to detach the Mast and Base

correctly.

Step 3 – Remove the Leg Actuator Cover. (Refer to section 9.8)

Step 4 – Place the Base on its side for easier service access.

Step 5 – Using Long Nose Pliers, bend the two retaining ends of the retaining clip forward to

straighten them to allow removal.

Step 6 – Grab the retaining clip from the looped end and pull the clip out of the pin as

shown.