FRICK
QUANTUM™ COMPRESSOR CONTROL PANEL S90-010 M
MAINTENANCE Page 41
SETPOINT DATA SHEETS
In most cases, updating software on the Quantum™ panel will require clearing the current setpoints and data stored in the
nonvolatile memory on the main board. It is suggested that the operator first record all control setpoints prior to performing
program chip upgrades. Panel Setup and Factory Setup settings will be lost when software is updated. The setpoint data
sheets are useful for recording this information.
FACTORY SETUP
Compressor model:
RWBII RXB RXF RDB, 4-STEP RDB, 3-STEP GSV II GST GSB GRAM/Other
SC YLC YORK S7
YORK S5
Other Var VI Other Manufacturer
Oil pump:
Demand No pump Prelube Cycling Full time Shaft w/Aux Shaft Dual
Oil filter:
Yes No
Refrigerant:
R11 R134a R717
R12 R290 - Propane R1270 - Propylene
R13 R404a R744 - CO2
R22 R500 R771
R113 R502 User-Defined
R114 R503
K-factor (If User-Defined): ______
Dual discharge control (used for swing machines):
Enabled Disabled
Liquid injection cooling:
Enabled Disabled
Main oil injection control (used for close-coupled, 2-stage packages):
Enabled Disabled
To Next Page
Loading...
