When all the entries making up the first
screen of the display have been
programmed, the second screen
appears automatically where stirring
can be adjusted (fig. 6).
When all the entries making up the first
and second screen of the display have
been programmed, the entry “NEXT
STEP” automatically appears selected
at the bottom of the screen.
Press “OK” to confirm the choice
(fig.7).
If however you wish to terminate the
changes and exit programming, press
“DOWN” to highlight the entry “OK” at
the bottom of the screen and then
press “OK” to confirm the choice
(Fig.8). This will make you access the
screen for saving the recipe just
created. (Fig. 9)
For stirring adjustment, operate the
same way as shown in the chapter
6.4.3.1 “CHANGE RECIPES” in the
relevant part.
The following screen highlights the
passage to step 2 where all the
adjustments shown for step 1 are
possible, and so on for all the
necessary steps up to a maximum of
15.
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9
To Next Page
Loading...
