We suggest using the following sanitising
solution:
Ecolab P3 Topax-san
(4% dilution = 200 ml every 5 litres of water).
• Pour the maximum admitted load of cold drinking
water into the tub to rinse the surfaces which were
just treated with the sanitizer.
• Drain the rinse water and turn the machine off.
• When pre-washing is over, all the removable parts in
contact with the product must be disassembled and
sanitised in a separate tub.
SANITISING REMOVABLE PARTS
PREPARATION OF WASHING TUB
• Wash your hands well and/or wear disposable
gloves.
• Fill a clean tub with a sufficient amount of drinking
water at approximately 50°C and the sanitizer.
• Prepare the supplied brush and the OR disassembly
device and immerse them in the solution.
REMOVING AND CLEANING OF THE COVER
• Pull the hinge pins off and remove the cover, holding
it with both hands.
• Emerge the previously disassembled components
into the tub with the sanitizer and brush the surfaces
with care. Pay special attention to the surfaces in
direct contact with the product.
REMOVING AND CLEANING OF THE UPPER
GRID
• Remove the hinge pins and remove the grid with
both hands.
• Immerse the previously removed components in the
tank with sanitizing solution and brush carefully all
surfaces
.
To Next Page
Loading...
