Closing the
housing
NOTE!
Ensure that the casing (2) lies in the
grooves of the front and back panels
1
Place the casing (1) on the power
source with the tab (2) pointing to-
wards the front panel
2
Fit the carrying handle
3
Fit two TX25 screws (4) Torque 3.0
Nm
4
Connect the positive lead of the
Accu- Pack (3), making sure it en-
gages
NOTE!
When fitting the control panel, ensure
that the ribbon cable is not trapped or
damaged.
5
Place the control panel on the
front panel and attach with two
TX25 screws (5). Torque: 3.0 Nm
31
EN
To Next Page
Loading...
