AccuPocket safety inspection
General This section outlines the safety inspection of the welding systems described in
this service manual. This section is fully compliant with IEC 60974-4. Extracts of
the requisite measuring methods are documented in Fronius work instruction
PMÜ-01.
Please also be aware of the requirements and standards relevant to your country,
as the measured values or steps taken during the tests may vary.
Should there be no relevant requirements and standards in your country, this
test should still be carried out.
Responsibility The repair engineer is responsible for carrying out and documenting the safety
inspection properly and for making the correct decision regarding the outcome
of the inspection.
Should any defects be identified during the test, then the entire safety inspec-
tion must be repeated once such defects have been rectified.
Should any defects be identified during the test, then the entire safety inspec-
tion must be repeated once such defects have been rectified. The following tests
must be performed in the prescribed sequence. Each test must be passed before
the next test is started. If it is not possible to perform a particular test, the ex-
aminer must decide whether the safety of the device can nevertheless still be
verified. Justifications for the resulting decision must be documented in the test
record under "Comments".
41
EN
To Next Page
Loading...
