Fronius IG-TL 4.0 - Safely Removing USB Sticks

86
The connected USB stick can then also be used to record logging data.
Re-insert the data communication rack.
Re-attach the screws to the data communication rack.
The current software version of the inverter can be viewed under the ‘Version’ menu item.
Individual settings in the Setup menu are retained when the inverter software is updated.
Safely removing
USB sticks
Remove the screws on the data communication rack.
Pull out the data communication rack.
Following the Startup phase, the inverter
begins to feed power into the grid.
The present output power is displayed
and the Operating Status LED lights up
green.
11
12
Select the ‘USB’ menu item.
Press the ‘Enter’ key.
‘Disconnect Device’ is displayed.
Press the ‘Enter’ key.
‘wait ...’ is briefly displayed.
1
2
3
4
5