17
EN
General
Principle
The Robacta Reamer V Twin is used for the
automatic cleaning of MIG/MAG welding
torches. The Robacta Reamer V Twin al-
lows you to clean the inside and front of the
gas nozzle on a wide range of welding torch
shapes. The result is a significant increase
in the service life of wearing parts. At the
same time, evenly applying parting agent
prevents the build-up of dirt.
Device concept The clamping device on the front of the Robacta Reamer V Twin holds the gas nozzle in
place during cleaning. A cleaning cutter is used to clean the nozzle. After the cleaning pro-
cess, a parting agent is applied to the inside and front of the gas nozzle through the spray
nozzle that is fixed in the middle of the cleaning motor.
The Robacta Reamer V Twin is fitted with a wire cutter as standard. During the cleaning
process, the Robacta Reamer V Twin shortens both wire electrodes to a defined length
ready for the next welding process.
A robust fitting base is available for the installation of the Robacta Reamer V Twin.
Application areas The cleaning device is exclusively intended for use in robot and other automated applica-
tions, and can be used for a wide range of materials.
The main application areas are:
- Automotive and component supply industry
- Equipment construction
- Chemical plant construction
- Machine and tracked vehicle manufacturing
- Construction machinery and special vehicles
To Next Page
Loading...
