Fronius Robacta Reamer V Twin - Ensuring that the Cleaning Device Is Depressurised

70
If work has to be performed on the cleaning device while it is supplied with voltage and/or
compressed air:
► Keep your body, especially your hands, face, hair, any objects and all clothing away
from the cleaning cutter, lifting device, gas nozzle clamping device, wire cutter and
parting-agent injection nozzle
► Wear ear protection
► Wear protective goggles with side protection
CAUTION!
A cleaning cutter that has become very hot through use can cause severe burns.
Before handling cleaning cutters, allow cleaning cutter to cool to room temperature (+25°C,
+77°F).
Ensuring that the
cleaning device is
depressurised
Attempt to briefly activate the cleaning device without any compressed air supply to check
whether the cleaning device is depressurised. Proceed as follows:
Take protective measures:
- The cleaning cutter, lifting device, gas nozzle clamping device, wire cutter and
parting-agent injection nozzle could start up. Therefore keep your body, especial-
ly your hands, face and hair, any objects and all clothing away from the parts re-
ferred to above
- Wear ear protection
- Wear protective goggles with side protection
Ensure that the cleaning device has been disconnected from the compressed air sup-
ply
Briefly turn the "Lifting device up/down" screw on the Robacta Reamer V Twin 90° to
the right, then turn it straight back to its original position.
- If the cleaning device does not respond to the turning of the screw, the cleaning device
is depressurised
- If the cleaning device responds to the turning of the screw, the cleaning device is still
connected to a compressed air supply. If this is the case, you must disconnect the
cleaning device from the compressed air supply and check again that the cleaning de-
vice is depressurised before starting work
1
2
3