34
Screwing the cleaning device to the underlying sur-
face
Screwing the
cleaning device
and installation
stand to the un-
derlying surface
NOTE!
Different fixings may be required to set up the installation stand depending on the
type of underlying surface (foundation).
Fixings are therefore not included in the scope of supply of the installation stand. The in-
staller is responsible for selecting the right type of fixing.
Place the optionally available installation stand on a level, firm and vibration-free sur-
face (foundation)
- Position the installation stand in such a way that the distance the robot has to trav-
el to the cleaning device on the installation stand is as short as possible
Screw the installation stand to the underlying surface (foundation) using the appropri-
ate fixings
Position the cleaning device on the in-
stallation stand
Position the spatter tray on the clea-
ning device as shown
Securely screw the cleaning device
and spatter tray to the installation
stand as shown. Use the fixings sup-
plied with the cleaning device
Screwing the
cleaning device
to the underlying
surface
NOTE!
Different fixings may be required to set up the device depending on the type of un-
derlying surface (foundation).
The fixings supplied may only be used on an underlying surface (foundation) thickness of
5 mm (0.197 in.) or less.
Do not use the fixings supplied to set up the device on an underlying surface (foundation)
thickness greater than 5 mm (0.197 in.). In this situation the installer is responsible for se-
lecting the right type of fixing.
Place the cleaning device on a level, firm and vibration-free surface (foundation)
- Position the cleaning device in such a way that the distance the robot has to travel
to the cleaning position is as short as possible
1
2
4 x
3
4
5
1
To Next Page
Loading...
