60
MIG/MAG modes
General
For details of the meaning, settings, setting range and units of the available welding pa-
rameters (e.g. gas pre-flow time), please refer to the "Set-up parameters" section.
Symbols
2-step mode “2-step mode“ is suitable for
- Tacking work
- Short weld seams
4-step mode "4-step mode" is suitable for longer weld seams.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
Press the torch trigger Hold the torch trigger Release the torch trigger
I
GPr GPo
t
I
+
To Next Page
Loading...
