Earthing test deactivated
The earthing test is deactivated.
- Four LEDs light up at 3, 6, 9 and 12 o'clock.
Internal communication fault
The Wattpilot displays an internal communication error. The
error code is displayed in the app. For more information, see
Status Codes.
- All LEDs flash red.
Residual current detected
The Wattpilot has detected a residual current (≥ 6 mA
DC
or ≥
30 mA
AC
). Restart the Wattpilot. For more information, see
Status Codes.
- The LEDs light up pink, the LEDs at the top flash red.
Earth fault detected
The earthing of the supply line to the Wattpilot is faulty. Check
the earthing of the supply line. For more information, see
Status Codes.
- The LEDs light up green and yellow, the LEDs at the top
flash red.
At least one phase of the power supply is missing
The phase(s) of the supply line to the Wattpilot has/have
failed. Check the phase(s) of the supply line. For more inform-
ation, see Status Codes.
- The LEDs light up blue, the LEDs at the top flash red.
Temperature too high
The temperature of the Wattpilot is too high. The charging cur-
rent is reduced. For more information, see Status Codes.
- The LEDs light up yellow, the LEDs at the top flash red.
Update
The Wattpilot firmware is being updated. The update can take
several minutes. Do not unplug the charging station.
- All LEDs flash pink, the progress of the update is indic-
ated by yellow LEDs.
18
To Next Page
Loading...
Need help?
General
