15
LUBRICATION AND MAINTENANCE
As is the case with any piece of new equipment, periodically check for loose
bolts and nuts. Paint and parts settling after the initial vibrations are common
and can cause bolts or nuts to loosen. Check the following parts frequently:
• Lug Bolts
• Tines & Tine Arms
• Guards
• Hydraulic Fittings
• All Fasteners
The plastic PTO shielding should be
lubricated at all times. If the shield
feels tight when it is extended and re-
tracted then lubricate as necessary.
The radial pin clutch and the center
cross in the PTO yokes should be
greased every 8 hours.
PTO Shaft Lubrication
To Next Page
Loading...