10-9
10.8 Replace Heating or Latching Contactor
1. Disconnect electrical power to the fryer.
2. Drain the cooking oil from the frypot.
3. Remove cap over elements.
4. If present, remove the wire harness connector covers on the front of the contactor box.
5. Disconnect the 15-pin controller plug from the front of the contactor box, Remove screw securing
contactor box in place. Lift the contactor box (Fig: 10-8) and push back slightly to release tabs
holding the box in the rear of the cabinet. Lift and pull the box forward to allow access to the plugs
at rear of unit.
6. Remove the screws securing the contactor. (See drawing on page 16-3)
7. Remove wiring connected to the contactor terminals. Mark wires for re-assembly
8. Remove the contactor mounting screws and contactor.
9. Install new contactor and attach wiring.
10. Reverse Steps 1-7 to complete job.
To Next Page
Loading...
