Flluid 1
39
When the auxiliary drive is switched on,
the motor takes over about half of the drive
power up to a speed of approx. 20mph (Fl-
luid 1) or 28pmh (Flluid 1S/1E)
From about 20 mph (Flluid-1) or about 28
mph (Flluid 1S/1E), the engine idles, Flluid
is driven only by muscle power.
Riding in pedelec operation
Start Up
WARNING – RISK OF INJURY!
A fall with serious injuries could be the
cause if the following points are not
observed:
1. Before riding off, hold the handlebar
(1) straight ahead
2. While getting familiar with your Flluid,
ride off with pedal power only and
only switch on the motor once you
are moving!
3. Only use the pedals (2) for starting
once a safe sitting and riding position
has been assumed.
4. When starting in the bend or on a
tight turn, lightly apply the handbrake
lever. This breaks the engine power
and enables safe riding.
All models can be operated with the auxiliary
drive switched on and without.
When the auxiliary drive is activated, you
can start the bike like with a normal bicycle.
When you press the pedals, the electric mo-
tor is activated and the bike is accelerated.
The more you push the pedals, the more
the engine will assist you.
RIDING
1
2
To Next Page
Loading...
